DESCRIPTION:Diesel Particular Filter (DPF) soot level very high. MONITORED PARAMETER:DPF Zone TYPICAL ENABLING CONDITIONS:Soot sensor enabled. MONITOR SEQUENCE:Continuously EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:Five seconds DASH LAMPS:SEL ENGINE REACTION:None VERIFICATION:Parked regeneration NOTE: When this code is active, driver has 2 minutes to execute the entry conditions: Cycle clutch switch, parking brake, neutral switch (automatics), and then initiate the regen process. If not completed, engine will shut down and regen procedure must be restarted. PROBABLE CAUSES:Perform a parked regeneration.

NOTE: This code is informational only and used by service to help understand which dash lights illuminated during normal service. A stationary regen is required if the fault code is active. No action required for an inactive fault code. NOTE: This is a silent code that logs when the DPF is in “Regen Zone 3”. If this code is staying active you need to perform a regen.

NOTE: Do not interrupt regeneration once it has been initiated. PROBABLE CUAUSES:When this code is detected, the operator has two minutes to execute the entry conditions:1. Cycle clutch switch (Manual transmission).2. Cycle parking brake.3. Cycle neutral switch (Automatic transmission).4. Then initiate regeneration request. NOTE: If this procedure is not completed within this time limit, the engine will shut down and the regeneration procedure must be restarted. NOTE: When this code is active, driver has 2 minutes to execute the entry conditions: Cycle clutch switch, parking brake, neutral switch (automatics), and then initiate the regen process. If not completed, engine will...

DESCRIPTION:Diesel Particular Filter (DPF) soot level high. MONITORED PARAMETER:DPF Zone TYPICAL ENABLING CONDITIONS:Soot sensor enabled. MONITOR SEQUENCE:Continuously EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:Five seconds DASH LAMPS:CEL ENGINE REACTION:None VERIFICATION:Parked regeneration NOTE: When this code is active, driver has 2 minutes to execute the entry conditions: Cycle clutch switch, parking brake, neutral switch (automatics), and then initiate the regen process. If not completed, engine will shut down and regen procedure must be restarted. PROBABLE CAUSES:Perform a parked regeneration.

NOTE: Silent code that logs when the diesel particulate filter regeneration lamp is flashing in ” Regen Zone 2″. This code is informational only and used by service to help understand which dash lights illuminated during normal service. A stationary regeneration is required if the fault code is active. No action is required for an inactive fault code. NOTE: This is a silent code that logs when the DPF is in “Regen Zone 2”. If this code is staying active you need to perform a regen.