The Engine Control Module (ECM) detects the following conditions: •The ECM is not receiving information about the ambient air temperature from the SAE J1587 data link. Probable Causes: 1) ECM Connection/Harness2) Truck batteries3) Wiring between batteries & ECM4) Fuses CAT 3406E (Prefix 5DS or 1LW) Fault Code: 00 PID: 171 SPN: FMI: 4 Ambient Air Temperature voltage low CAT 3406E (Prefix 5DS or 1LW) Fault Code: 00 PID: 171 SPN: FMI: 3 Ambient Air Temperature voltage high CAT 3406E (Prefix 5DS or 1LW) Fault Code: 00 PID: 84 SPN: FMI: 14 Quick Stop Occurrence Volvo All Engines (2010 Emissions) Fault...

The ECM detects the following conditions: •The signal voltage from the ambient air temperature sensor is greater than 4.92 VDC for more than eight seconds.•The “Allow Idle Shutdown Override” parameter is programmed to “Outside Temperature Based” or “J1587 Outside Temperature Based”.•The ECM has been powered for at least two seconds. Probable Causes: 1) ECM Connection/Harness2) If code 232-3 or 232-4 (5 Volt Supply voltage codes) are active, troubleshoot those instead3) Temperature sensor failure4) Temperature sensor harness5) ECM Failure CAT 3406E (Prefix 5DS or 1LW) Fault Code: 00 PID: 84 SPN: FMI: 14 Quick Stop Occurrence Volvo All Engines (2010 Emissions)...

The Engine Control Module (ECM) detects the following conditions: •The signal voltage from the ambient air temperature sensor is less than 0.2 VDC for more than eight seconds.•The “Allow Idle Shutdown Override” parameter is programmed to “Outside Temperature Based” or “J1587 Outside Temperature Based”.•The ECM has been powered for at least two seconds. Probable Causes: 1) ECM Connection/Harness2) If code 232-3 or 232-4 (5 Volt Supply voltage codes) are active, troubleshoot those instead3) Temperature sensor failure4) Temperature sensor harness5) ECM Failure CAT 3406E (Prefix 5DS or 1LW) Fault Code: 00 PID: 171 SPN: FMI: 3 Ambient Air Temperature voltage high...

The Engine Control Module (ECM) detects the following conditions: •The vehicle speed slows at a rate that exceeds the “Quick Stop Rate” that is programmed.•The service brake is applied. Probable Causes: •The parameter for the “Quick Stop Rate” may be set too low. Note: This setting can be affected by the load on the vehicle. If the vehicle is operated without a trailer or with no load, the vehicle will stop faster than the same vehicle with a heavy load. Volvo All Engines (2010 Emissions) Fault Code: SPN 98 FMI 18 PID: Engine Oil Level – Moderately Severe Level Volvo...

The Engine Control Module (ECM) detects one of the following conditions: •The “Allow Idle Shutdown Override” parameter is programmed to “Yes” and the status of the brake switch or the clutch switch changes.•The “Allow Idle Shutdown Override” parameter is programmed to “J1587 Outside Temp Based” or “Outside Temperature Based”. The outside temperature is above the maximum programmed temperature or the outside temperature is below the minimum programmed temperature.•The idle shutdown timer is within the final 90 seconds.•The “Idle Shutdown Time” parameter is programmed to at least three minutes. Probable Causes: 1) It code 84-08 is active, Idle Shutdown Timer will...