Detroit Diesel
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1624 FMI 19 (CPC) Tachograph Vehicle Speed Signal is Erratic
Posted by PerDiezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: If any battery voltage codes present, first those first. If code 625-9 active, fix that before proceeding as well. PROBABLE CAUSES:1. CPC recently programmed incorrectly.2. Another computer on the truck is the cause of the problems (ABS, Transmission, etc…).
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1624 FMI 9 (CPC) Message is Missing
Posted by PerDiezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: If any battery voltage codes present, first those first. If code 625-9 active, fix that before proceeding as well. PROBABLE CAUSES:1. CPC recently programmed incorrectly.2. Another computer on the truck is the cause of the problems (ABS, Transmission, etc…).
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1636 FMI 20 (MCM) Intake Manifold Temperature Drift (Low Box)
Posted by PerDiezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. PROBABLE CAUSES:1. Intake manifold pressure/temperature sensor.2. Intake manifold pressure/temperature sensor connector/harness.
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1636 FMI 3 (MCM) Intake Manifold Temperature Circuit Failed High
Posted by PerDiezel Solutions on
DESCRIPTION:Intake manifold temperature circuit failed high. MONITORED PARAMETER:Intake manifold temperature sensor. TYPICAL ENABLING CONDITIONS:Always enabled MONITOR SEQUENCE:None EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:Two seconds DASH LAMPS:1. MIL2. CEL ENGINE REACTION:Derate 25% VERIFICATION:Engine Idle: One minute. PROBABLE CAUSES:1. Intake manifold pressure/temperature sensor.2. Intake manifold pressure/temperature sensor connector/harness.
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1636 FMI 4 (MCM) Intake Manifold Temperature Circuit Failed Low
Posted by PerDiezel Solutions on
DESCRIPTION:Intake manifold temperature circuit failed low. MONITORED PARAMETER:Intake manifold temperature sensor. TYPICAL ENABLING CONDITIONS:Always enabled MONITOR SEQUENCE:None EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:Two seconds DASH LAMPS:1. MIL2. CEL ENGINE REACTION:Derate 25% VERIFICATION:Engine Idle: One minute. PROBABLE CAUSES:1. Intake manifold pressure/temperature sensor.2. Intake manifold pressure/temperature sensor connector/harness.
