The Engine Control Module (ECM) detects the following conditions:
•The vehicle speed slows at a rate that exceeds the “Quick Stop Rate” that is programmed.
•The service brake is applied.
Probable Causes:
•The parameter for the “Quick Stop Rate” may be set too low.
Note: This setting can be affected by the load on the vehicle. If the vehicle is operated without a trailer or with no load, the vehicle will stop faster than the same vehicle with a heavy load.
Volvo All Engines (2010 Emissions) Fault Code: SPN 98 FMI 18 PID: Engine Oil Level – Moderately Severe Level
Volvo All Engines (2010 Emissions) Fault Code: SPN 98 FMI 1 PID: Engine Oil Level
Volvo All Engines (2010 Emissions) Fault Code: SPN 975 FMI 3 PID: Estimated Percent Fan Speed
Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 4 PID: Water in Fuel Indicator
Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 3 PID: Water in Fuel Indicator
