Fault Condition: FMI 5 indicates there is an open circuit in the starter relay control circuit. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Vehicle Electronic Control Unit (VECU) connector B. With Eaton A/T, disconnect the 20 Starter Enable Relay. Without Eaton A/T, disconnect the 36 Start Cntrl 1 Relay. With Eaton A/T, check for continuity between the Vehicle Electronic Control Unit (VECU) connector B pin 28 and 20 Starter Enable Relay pin 30. Without Eaton A/T, check for continuity between the Vehicle (VECU) connector B pin 28 and 36 Start Cntrl 1 Relay pin 85. If...

Fault Condition: FMI 7 indicates that starter engagement has been denied because the automated/automatic transmission is not in neutral. Possible repairs: Turn the ignition key OFF first. 1) If the FMI is 7 (mechanical system not responding), the starter engagement has been denied because the automated/automatic transmission is not in neutral. Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 10 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 14 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 0 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI...

Fault Condition: If the Engine Management System (EMS) Module detects a fault in the electrical circuit while attempting to operate the Fuel Injector Unit, the Electronic Malfunction Lamp (EML) will turn ON and code SID 4 will set. Possible repairs: Turn the ignition switch OFF first. 1) Disconnect the harness electrical connector from Fuel Injector Unit #4. Check for continuity between the pins 1 and 2 of the Fuel Injector Unit #4. If the resistance is NOT between 0.9-5.2 Ohms at 68°F (20°C) or 1.5-5.8 Ohms at 218°F (103°C), Fuel Injector #4 is faulty and must be replaced.2) Disconnect the...

Fault Condition: If the Engine Management System (EMS) Module detects a fault in the electrical circuit while attempting to operate the Fuel Injector Unit, the Electronic Malfunction Lamp (EML) will turn ON and code SID 4 will set. Possible repairs: Turn the ignition switch OFF first. 1) Disconnect the harness electrical connector from Fuel Injector Unit #4. Check for continuity between the pins 1 and 2 of the Fuel Injector Unit #4. If the resistance is NOT between 0.9-5.2 Ohms at 68°F (20°C) or 1.5-5.8 Ohms at 218°F (103°C), Fuel Injector #4 is faulty and must be replaced.2) Disconnect the...

Fault Condition: If the Engine Management System (EMS) Module detects a fault in the electrical circuit while attempting to operate the Fuel Injector Unit, the Electronic Malfunction Lamp (EML) will turn ON and code SID 4 will set. Possible repairs: Turn the ignition switch OFF first. 1) Disconnect the harness electrical connector from Fuel Injector Unit #4. Check for continuity between the pins 1 and 2 of the Fuel Injector Unit #4. If the resistance is NOT between 0.9-5.2 Ohms at 68°F (20°C) or 1.5-5.8 Ohms at 218°F (103°C), Fuel Injector #4 is faulty and must be replaced.2) Disconnect the...