The preheat function is used to warm up the inlet air during cold conditions both before and after cranking to make the starting easier and better for the environment at very low temperatures. This diagnostic trouble code (DTC) detects a faulty preheat function.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:7 is more than 91?% battery voltage
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Intake air heater (IAH) relay may be constantly activated
2) High intake air temperature (IAT)
3) High current consumption
4) Power loss
5) Low battery voltage
Probable cause
1) Connector
2) Wiring harness
3) Intake air heater (IAH) relay
Volvo All Engines (2010 Emissions) Fault Code: SPN 677 FMI 5 PID: SID 39 Engine Starter Motor Relay
Volvo All Engines (2010 Emissions) Fault Code: SPN 677 FMI 4 PID: SID 39 Engine Starter Motor Relay
Volvo All Engines (2010 Emissions) Fault Code: SPN 677 FMI 3 PID: SID 39 Engine Starter Motor Relay
Volvo All Engines (2010 Emissions) Fault Code: SPN 656 FMI 7 PID: SID 6 Engine Injector Cylinder 6
Volvo All Engines (2010 Emissions) Fault Code: SPN 656 FMI 12 PID: SID 6 Engine Injector Cylinder 6
Volvo All Engines (2010 Emissions) Fault Code: SPN 655 FMI 7 PID: SID 5 Engine Injector Cylinder 5
