25% Discount for payments with Crypto Currency



Volvo All Engines (2010 Emissions) Fault Code: SPN 677 FMI 3 PID: SID 39 Engine Starter Motor Relay

Posted by PerDiezel Solutions on

The (VECU) Vehicle Electronic Control Unit supplies and monitors the cranking signal to the starter motor relay. Several types of starter cranking protection are provided so the starter cannot be engaged in unwanted conditions. The starter cranking protection will also limit the maximum cranking time to 18 seconds without cycling the key

Conditions for diagnostic trouble code (DTC):
1) Output A14.EB:29 active
2) Short circuit to battery voltage
3) This diagnostic trouble code (DTC) is set only when the ignition key is held in the start position for approximately 3?s

Observable symptoms
1) Starter motor does not run

Probable cause
1) Wire between Engine Control Module (ECM) and starter motor relay
2) Starter motor relay (K65)

Volvo All Engines (2010 Emissions) Fault Code: SPN 656 FMI 7 PID: SID 6 Engine Injector Cylinder 6
Volvo All Engines (2010 Emissions) Fault Code: SPN 656 FMI 12 PID: SID 6 Engine Injector Cylinder 6
Volvo All Engines (2010 Emissions) Fault Code: SPN 655 FMI 7 PID: SID 5 Engine Injector Cylinder 5
Volvo All Engines (2010 Emissions) Fault Code: SPN 655 FMI 12 PID: SID 5 Engine Injector Cylinder 5
Volvo All Engines (2010 Emissions) Fault Code: SPN 655 FMI 12 PID: SID 5 Engine Injector Cylinder 5
Volvo All Engines (2010 Emissions) Fault Code: SPN 654 FMI 7 PID: SID 4 Engine Injector Cylinder 4

PerDieselSolution Logo

WARNING!

PerDieselSolution informs all customers and visitors that fake websites and copied domains are being used by scammers.

Please make sure you are visiting our ONLY official website:

perdieselsolution.com

We publish this notice to protect our customers from fraudulent stores and unofficial sellers.