Detroit Diesel
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 91 FMI 7 (CPC) 2-Channel Accelerator Pedal Idle Not Recognized
Posted by PerDiezel Solutions on
DESCRIPTION:Idle position not reached 20 minutes after ignition on. MONITORED PARAMETER:Pedal position TYPICAL ENABLING CONDITIONS:Always on MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:2 seconds DASH LAMPS:None ENGINE REACTION:None VERIFICATION:Key cycle: Ignition on. PROBABLE CAUSES:1. If any other active codes, fix those first.2. Accelerator pedal failure.3. Accelerator pedal wiring/harness.
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 91 FMI 8 (CPC) 2-Channel Accelerator Pedal Signal 1 Missing
Posted by PerDiezel Solutions on
DESCRIPTION:Channel 1 sensor signal failed (High or low). MONITORED PARAMETER:Gas 1 TYPICAL ENABLING CONDITIONS:Always on MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:2 seconds DASH LAMPS:CEL ENGINE REACTION:None VERIFICATION:Key Cycle: ignition on. PROBABLE CAUSES:1. Accelerator pedal assembly.2. Accelerator pedal harness/connector.
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 94 FMI 15 (MCM) Fuel Filter Service Warning
Posted by PerDiezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: This fault indicates that the fuel filters on the engine must be replaced.
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 94 FMI 16 (MCM) Fuel Filter Replacement Required
Posted by PerDiezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: This fault indicates that the fuel filters on the engine must be replaced.
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 94 FMI 3 (MCM) Fuel Compensation Pressure Sensor Circuit Failed High
Posted by PerDiezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. PROBABLE CAUSES:1. If 100-3, 4077-3, and 94-3 are also present, repair the wiring between pin 82 of the ECM connection and the engine oil pressure, fuel line, and fuel compensation pressure sensors.2. If 4407-3 and 94-3 are present, repair the wiring between pin 104 of the ECM connection and the fuel line and fuel compensation pressure sensor.3. Fuel Compensation Pressure sensor.4. Fuel compensation pressure harness/connector.
