CAT
CAT 3126E Fault Code: 253-14 PID: Flash Code 56 SPN: FMI: Truck Manufacturer Paremater Not Programmed
Posted by PerDiezel Solutions on
The “Truck Manufacturer Parameter” has not been programmed. The parameter must be programmed for the manufacturer of the chassis in order to configure the correct options and ranges for the engine. Note: The “Truck Manufacturer Parameter” must be programmed before the “Customer Parameters” are programmed. Probable Causes: 1) ECM not programmed correctly CAT 3126E Fault Code: 253-02 PID: Flash Code 56 SPN: 630 FMI: 2 Check Customer or System Parameters CAT 3126E Fault Code: 168-02 PID: Flash Code 51 SPN: 168 FMI: 2 ECM Battery Power Intermittent CAT 3126E Fault Code: 168-01 PID: Flash Code 51 SPN: 168 FMI: 1...
CAT 3126E Fault Code: 3-11 PID: Flash Code 73 SPN: 653 FMI: 11 Cylinder #3 Injector current fault
Posted by PerDiezel Solutions on
The Engine Control Module (ECM) detects one of the following items after attempting to operate the injector: •A low current condition (open circuit) exists in the wiring for the cylinder injector solenoid.•A high current condition (short circuit) exists in the injector solenoid. Probable Causes: 1) ECM Connection/Harness2) Cylinder injector failure3) Injector solenoid failure4) Harness from ECM to valve cover connector5) ECM failure6) Injector harness under valve cover CAT 3126E Fault Code: 2-11 PID: Flash Code 72 SPN: 652 FMI: 11 Cylinder #2 Injector current fault CAT 3126E Fault Code: 1-11 PID: Flash Code 72 SPN: 651 FMI: 11 Cylinder #1...
CAT 3126E Fault Code: 30-08 PID: Flash Code 29 SPN: FMI: Invalid PTO Throttle Signal
Posted by PerDiezel Solutions on
The idle timer has expired to stop the engine. NOTE: This diagnostic code represents an event and not an Electronic System fault. CAT 3126E Fault Code: 91-13 PID: Flash Code 28 SPN: FMI: Throttle Sensor Calibration CAT 3126E Fault Code: 110-04 PID: Flash Code 27 SPN: 110 FMI: 4 Coolant Temperature Sensor Short Circuit CAT 3126E Fault Code: 110-03 PID: Flash Code 27 SPN: 110 FMI: 3 Coolant Temperature Sensor Open Circuit CAT 3126E Fault Code: 108-04 PID: Flash Code 26 SPN: 108 FMI: 4 Barometric Pressure voltage low CAT 3126E Fault Code: 108-03 PID: Flash Code 26 SPN: 108...
CAT 3126E Fault Code: 30-13 PID: Flash Code 29 SPN: FMI: PTO Throttle Sensor Calibration
Posted by PerDiezel Solutions on
The Personality Module installed is for a different engine than the Personality Module it replaced. NOTICE: Do not attempt to install a 3126 Personality Mofule into a 3116 engine or a 3116 Personality Module into a 3126 engine. Serious engine damage may occur when the engine is started. CAT 3126E Fault Code: 30-08 PID: Flash Code 29 SPN: FMI: Invalid PTO Throttle Signal CAT 3126E Fault Code: 91-13 PID: Flash Code 28 SPN: FMI: Throttle Sensor Calibration CAT 3126E Fault Code: 110-04 PID: Flash Code 27 SPN: 110 FMI: 4 Coolant Temperature Sensor Short Circuit CAT 3126E Fault Code: 110-03...
CAT 3126E Fault Code: 4-11 PID: Flash Code 73 SPN: 654 FMI: 11 Cylinder #4 Injector current fault
Posted by PerDiezel Solutions on
The Engine Control Module (ECM) detects one of the following items after attempting to operate the injector: •A low current condition (open circuit) exists in the wiring for the cylinder injector solenoid.•A high current condition (short circuit) exists in the injector solenoid. Probable Causes: 1) ECM Connection/Harness2) Cylinder injector failure3) Injector solenoid failure4) Harness from ECM to valve cover connector5) ECM failure6) Injector harness under valve cover CAT 3126E Fault Code: 3-11 PID: Flash Code 73 SPN: 653 FMI: 11 Cylinder #3 Injector current fault CAT 3126E Fault Code: 2-11 PID: Flash Code 72 SPN: 652 FMI: 11 Cylinder #2...
