The “Truck Manufacturer Parameter” has not been programmed. The parameter must be programmed for the manufacturer of the chassis in order to configure the correct options and ranges for the engine.
Note: The “Truck Manufacturer Parameter” must be programmed before the “Customer Parameters” are programmed.
Probable Causes:
1) ECM not programmed correctly
CAT 3126E Fault Code: 168-02 PID: Flash Code 51 SPN: 168 FMI: 2 ECM Battery Power Intermittent
CAT 3126E Fault Code: 168-01 PID: Flash Code 51 SPN: 168 FMI: 1 Low ECM Battery Power
CAT 3126E Fault Code: 168-00 PID: Flash Code 51 SPN: 168 FMI: 0 Excessive ECM Battery Power
CAT 3126E Fault Code: 70-06 PID: Flash Code 49 SPN: 729 FMI: 6 Inlet Air Heater Short Circuit
CAT 3126E Fault Code: 70-05 PID: Flash Code 49 SPN: 729 FMI: 5 Inlet Air Heater Open Circuit
