Fault Condition: FMI 14 indicates the PTO is engaged and locks out the starter motor operation. Possible repairs: Turn the ignition key OFF first. 1) If the FMI is 14 (programming failure), the PTO is engaged and locks out the starter motor operation. Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 0 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI 3 Sensor Supply Voltage #2 Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI 4 Sensor Supply Voltage #2 Volvo All Engines (2004 Emissions) Fault Code: SID 232 FMI 3 Sensor Supply Voltage...

Fault Condition: FMI 3 indicates there is a short circuit to voltage in the starter relay control circuit. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Vehicle Electronic Control Unit (VECU) connector B. Turn the ignition key ON. Measure the voltage between the VECU connector B pin 28 and a good ground. If voltage is present, the control line circuit isshorted to voltage. Locate the short to voltage, repair the circuit and retest the system. If there is NO voltage present, verify the diagnostic code, the FMI and retest the system. If the FMI 3 is still...

Fault Condition: FMI 4 indicates there is a short circuit to ground in the starter relay control circuit. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Vehicle Electronic Control Unit (VECU) connector B. Check for continuity between the Vehicle Electronic Control Unit (VECU) connector B pin 28 and a good ground. If continuity exists to ground, locate andrepair the short circuit to ground. If there is NO continuity, verify the diagnostic code, the FMI and retest the system. If the FMI 4 is still active, replace the VECU and retest the system. Volvo All Engines (2004 Emissions)...

Fault Condition: FMI 5 indicates there is an open circuit in the starter relay control circuit. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Vehicle Electronic Control Unit (VECU) connector B. With Eaton A/T, disconnect the 20 Starter Enable Relay. Without Eaton A/T, disconnect the 36 Start Cntrl 1 Relay. With Eaton A/T, check for continuity between the Vehicle Electronic Control Unit (VECU) connector B pin 28 and 20 Starter Enable Relay pin 30. Without Eaton A/T, check for continuity between the Vehicle (VECU) connector B pin 28 and 36 Start Cntrl 1 Relay pin 85. If...

Fault Condition: FMI 7 indicates that starter engagement has been denied because the automated/automatic transmission is not in neutral. Possible repairs: Turn the ignition key OFF first. 1) If the FMI is 7 (mechanical system not responding), the starter engagement has been denied because the automated/automatic transmission is not in neutral. Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 10 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 14 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 0 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI...