Conditions for diagnostic trouble code (DTC):1) Short circuit to battery voltage on A14.EB:23 Diagnostic operating conditions1) Ignition key in ON position Observable symptoms1) Coolant level cannot be detected Probable cause1) Connector2) Wiring harness3) ECM – Engine Control Module Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 18 PID: Engine Coolant Level – Moderately Severe Level Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 1 PID: Engine Coolant Level Volvo All Engines (2010 Emissions) Fault Code: SPN 110 FMI 5 PID: Engine Coolant Temperature Volvo All Engines (2010 Emissions) Fault Code: SPN 110 FMI 4 PID: Engine...

Conditions for diagnostic trouble code (DTC):1) Short circuit to ground on A14.EB:23 Diagnostic operating conditions1) Ignition key in ON position Observable symptoms1) Coolant level cannot be detected Probable cause1) Connector2) Wiring harness3) Engine Coolant Level (ECL) Sensor4) ECM – Engine Control Module Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 3 PID: Engine Coolant Level Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 18 PID: Engine Coolant Level – Moderately Severe Level Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 1 PID: Engine Coolant Level Volvo All Engines (2010 Emissions) Fault Code: SPN 110...

Conditions for diagnostic trouble code (DTC):1) The voltage at pin A14.EB:23 is below normal value Diagnostic operating conditions1) Ignition key in ON position Observable symptoms1) Coolant level cannot be detected Probable cause1) Connector2) Wiring harness3) Engine Coolant Level (ECL) Sensor4) Short circuit to ground5) ECM – Engine Control Module Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 4 PID: Engine Coolant Level Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 3 PID: Engine Coolant Level Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 18 PID: Engine Coolant Level – Moderately Severe Level Volvo All...

The engine control module (ECM) monitors the intake manifold pressure (IMP) sensor and controls the boost air system (mainly controlled by the VGT) and the engine turbocharger compressor bypass valve. The ECM also uses parameters like engine speed (RPM) and turbocharger speed to make a calculation of the IMP. This estimated value should not differ too much from the measured value. Conditions for diagnostic trouble code (DTC):1) Poor intake manifold pressure (IMP) response Observable symptoms1) Power loss2) Poor response Probable cause1) Charge air system leakage Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 5 PID: Engine Coolant Level...

The engine control module (ECM) monitors the intake manifold pressure (IMP) sensor and controls the boost air system (mainly controlled by the VGT) and the engine turbocharger compressor bypass valve. The ECM also uses parameters like engine speed (RPM) and turbocharger speed to make a calculation of the IMP. This estimated value should not differ too much from the measured value. Conditions for diagnostic trouble code (DTC):1) Regulation of Variable Geometry Turbo (VGT) or Exhaust Gas Recirkulation (EGR) system not possible Probable cause1) Turbocharger Volvo All Engines (2010 Emissions) Fault Code: SPN 1127 FMI 10 PID: Engine Turbocharger 1 Boost...