Fault Condition: The Electronic Malfunction Lamp (EML) will turn on and PID 175 will set if the engine oil temperature signal voltage is less than .17 volts or greater than 4.92 volts. If the EMS Module senses that the engine oil temperature signal is critically above range, FMI code 0 will be set. If the engine oil temperature reaches 259°F (126°C), the engine power will be reduced by 15%. If the engine oil temperature reaches 262°F (128°C), the engine will be shutdown. Yellow or red warning lamp identification and buzzer warning will accompany the extreme engine oil temperature conditions. If...

Fault Condition: The Electronic Malfunction Lamp (EML) will turn on and PID 175 will set if the engine oil temperature signal voltage is less than .17 volts or greater than 4.92 volts. If the EMS Module senses that the engine oil temperature signal is critically above range, FMI code 0 will be set. If the engine oil temperature reaches 259°F (126°C), the engine power will be reduced by 15%. If the engine oil temperature reaches 262°F (128°C), the engine will be shutdown. Yellow or red warning lamp identification and buzzer warning will accompany the extreme engine oil temperature conditions. If...

Fault Condition: The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management. The Transmission Oil Temperature Sensor sends a signal to the Instrument Cluster Module (ICM) which relays a signal to the Engine Management System (EMS) Module via the data lines. Possible repairs: 1) Verify that code PID 177 is set. If code PID 177 is not set, wiggle the harness and connectors to try to set the code. Visually inspect the VECU connectors and wires for poor connections.2) Turn the ignition key OFF and connect...

Fault Condition: The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management. The Transmission Oil Temperature Sensor sends a signal to the Instrument Cluster Module (ICM) which relays a signal to the Engine Management System (EMS) Module via the data lines. Possible repairs: 1) Verify that code PID 177 is set. If code PID 177 is not set, wiggle the harness and connectors to try to set the code. Visually inspect the VECU connectors and wires for poor connections.2) Turn the ignition key OFF and connect...

Fault Condition: If code PID 190 is displayed, the engine has been overspeeding. The engine could be running on engine oil from a faulty crankcase oil filter or worn engine piston rings. The engine speed will be limited to to approximately 1200 rpm and the VCB and the EPD will be activated to lower the engine speed. Diagnose and repair the engine overspeed condition. Volvo All Engines (2004 Emissions) Fault Code: PID 98 FMI 1 Engine Oil Level / Temperature Sensor Volvo All Engines (2004 Emissions) Fault Code: PID 98 FMI 4 Engine Oil Level / Temperature Sensor Volvo All...