Overview:
Fault Code 32 indicates the switched system voltage from the Shift Controller on Pin J2 and Pin K2 is below 7 volts.
Detection:
The fault is detected immediately after power up.
Fallback:
This fault causes an in-place fallback.
Possible Causes:
1) Low batteries
2) OEM Harness
3) Shift Controller
Shop Talk:
Key on. If the fault is present, the system should automatically detect the problem and set the code. If the fault is not present at key on, operate the vehicle and attempt to duplicate the driving conditions that triggered the fault code. Possible triggers include heat, vibration.
Eaton Gen 2 (AutoShift) Fault Code: 31 PID: SID 218 FMI: 4 Momentary Ignition Interrupt Relay
Eaton Gen 2 (AutoShift) Fault Code: 31 PID: SID 218 FMI: 3 Momentary Ignition Interrupt Relay
Eaton Gen 2 (AutoShift) Fault Code: 28 PID: SID 52 FMI: 7 Clutch System Fault
Eaton Gen 2 (AutoShift) Fault Code: 28 PID: SID 52 FMI: 5 Clutch System Fault
Eaton Gen 2 (AutoShift) Fault Code: 28 PID: SID 52 FMI: 4 Clutch System Fault
Eaton Gen 2 (AutoShift) Fault Code: 28 PID: SID 52 FMI: 3 Clutch System Fault
