Cummins ISB CM850 (2003-06) Fault Code: 281 PID: SID 126 SPN: 1347 FMI: 7 Fuel Pump Pressurizing Assembly 1 – Mechanical System Not Responding Properly or Out of Adjustment. A pumping imbalance between the front and rear pumping plungers has been detected. Fault Code 281 will most likely come active while operating at a steady state loaded condition. At this condition commanded fuel pressures are highest and the pump’s pressure balance is affected the most. If a high pressure seal has failed, pump head drain flow will be excessive. If a seal failure has progressed far enough, the engine may...

Cummins ISB CM850 (2003-06) Fault Code: 284 PID: SID 221 SPN: 1043 FMI: 4 Engine Speed/Position Sensor (Crankshaft) Supply Voltage Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected on the ECM voltage supply line to engine speed sensor. Low voltage on the +5 VDC supply line can be caused by a short circuit to ground in a supply line, a short circuit between a supply line or a return line, a failed sensor, or a failed ECM power supply. Possible repairs: 1)Replace the engine speed sensor.2)Replace the engine harness.3)Replace the ECM. Cummins ISB CM850 (2003-06)...

Cummins ISB CM850 (2003-06) Fault Code: 285 PID: SID 231 SPN: 639 FMI: 9 SAE J1939 Multiplexing PGN Timeout Error – Abnormal Update Rate. The Cummins? ECM did not receive a multiplexed message from an OEM VECU or SIM within the time limit or did not receive it at all. Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe? Online for applicable fixes to the calibration stored in the ECM. If necessary, calibrate the ECM. Refer to Procedure 019-032 in Section 19. When this fault code is active, some multiplexed devices may...

Cummins ISB CM850 (2003-06) Fault Code: 286 PID: SID 231 SPN: 639 FMI: 13 SAE J1939 Multiplexing Configuration Error – Out of Calibration. The ECM expected information from a multiplexed device but only received a portion of the necessary information. Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe? Online for applicable fixes to the calibration stored in the ECM. If necessary, calibrate the ECM. This fault can occur when the ECM is set up properly (components enabled and OEM VECU source addressed correctly) to receive information from an OEM VECU, but...

Cummins ISB CM850 (2003-06) Fault Code: 287 PID: 91 SPN: 91 FMI: 19 SAE J1939 Multiplexing Accelerator Pedal or Lever Sensor System Error – Received Network Data Error. The OEM vehicle electronic control unit (VECU) detected a fault with its accelerator pedal. This fault can occur when the OEM VECU detects an error on the accelerator and or idle validation switch. The ECM has been set up properly (components enabled and OEM VECU source addressed correctly) to receive multiplexed information for the idle validation switch states and accelerator position over the J1939 datalink from an OEM VECU, and the OEM...