Cummins ISB CM850 (2003-06) Fault Code: 2375 PID: 412 SPN: 412 FMI: 3 EGR Temperature Sensor Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage detected at the EGR temperature sensor circuit. This fault code is set active if the sensor signal voltage is above the normal operating range for the sensor and the ECM has commanded the EGR valve open. This fault code will not be set active if the ECM has commanded the EGR valve closed. However, once the fault code is set, it will remain active independent of whether the EGR valve is...

Cummins ISB CM850 (2003-06) Fault Code: 2376 PID: 412 SPN: 412 FMI: 2 Recirculation Exhaust Gas (EGR) Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the EGR temperature circuit. This fault code is set active if the sensor signal voltage is below the normal operating range for the sensor and the electronic control module (ECM) has commanded the EGR valve open. This fault code will not be set active if the ECM has commanded the EGR valve closed. However, once the fault code is set, it will remain active independent of...

Cummins ISB CM850 (2003-06) Fault Code: 2377 PID: SID 33 SPN: 647 FMI: 3 Fan Control Circuit – Voltage Above Normal or Shorted to High Source. Open circuit or high voltage detected at the fan control circuit. The ECM monitors the voltage level on this circuit. When the ECM commands the fan signal low, it expects the voltage level to be approximately 0 volts. If it detects a high voltage, this fault is recorded. If Fault Code 2377 is still active after completing the following troubleshooting steps, consult the OEM service literature for procedures to check the fan clutch device...

Cummins ISB CM850 (2003-06) Fault Code: 238 PID: SID 232 SPN: 611 FMI: 4 Sensor Supply 3 Circuit – Voltage Below Normal, or Shorted to Low Source. Low voltage detected on the +5 volt sensor supply circuit to the engine speed sensor. Low voltage on the +5 VDC supply line can be caused by a short circuit to ground in a supply line, a short circuit between a supply line or a return line, a failed sensor, or a failed ECM power supply. Possible repairs: 1)Replace the engine speed sensor. Cummins ISB CM850 (2003-06) Fault Code: 237 PID: SID 30...

Cummins ISB CM850 (2003-06) Fault Code: 2381 PID: SPN: 2795 FMI: 4 Turbocharger position sensor circuit – shorted high. High signal voltage detected at the turbocharger position sensor circuit. The turbocharger position sensor shares supply and return wires in the engine harness with other sensors. Opens and shorts in the engine harness can cause multiple fault codes to be active. Possible causes: 1)Open return circuit in the harness, connectors, or sensor2)Signal shorted to sensor supply or battery voltage3)Failed ECM4)Failed VGT position sensor. Possible repairs: 1)Replace the turbocharger position sensor.2)Repair or replace the engine harness.3)Replace the ECM. Cummins ISB CM850 (2003-06)...