Cummins ISB4.5 CM2150 Fault Code: 3735 PID: SPN: 2884 FMI: 9 Engine Auxiliary Governor Switch – Abnormal Update Rate.

Posted by PerDiezel Solutions on January 20, 2026

Circuit Description
Devices such as ABS controllers, autoshift transmissions, ASR systems, electronic displays, electronic information systems, electronic service tools, and vehicle electronic control unit(s) (VECUs) can communicate with the ECM over the SAE J1939 data link. Messages sent from the devices are received by the ECM and used for controlling the engine. The ECM also transmits information to these devices over the SAE J1939 data link.

Component Location
The SAE J1939 data link wiring and the SAE J1939 devices vary by OEM options. Refer to the OEM service manual.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position.

Conditions for Setting the Fault Codes
The ECM does not receive a valid J1939 message from a multiplexed device for more than one second. The ECM detects an open or short circuit condition in the J1939 data link harness.

Action Taken When the Fault Code is Active
-The ECM will log the fault code immediately when the diagnostic runs and fails.
-The ECM will use a default state as an input for the multiplexed device.

Conditions for Clearing the Fault Code
-To validate the repair, start the engine and let it idle for 1 minute.
– The fault code status will change to INACTIVE in INSITE™ electronic service tool immediately after the diagnostic runs and passes.
-The fault code can also be cleared with INSITE™ electronic service tool.

Possible Causes
-Electrical problems with the SAE J1939 data link wiring such as grounded, shorted, or open circuits
-The ECM (or another SAE J1939 device) tying up communications by sending too many consecutive messages
-The external OEM controlling device has malfunctioned or can no longer transmit on the data link.

Cummins ISB4.5 CM2150 Fault Code: 3731 PID: SPN: 5110 FMI: 9 Instrument Cluster Control Module – Abnormal Update Rate.

Cummins ISB4.5 CM2150 Fault Code: 3713 PID: SID 254 SPN: 5491 FMI: 7 Aftertreatment Diesel Exhaust Fluid Line Heater Relay – Mechanical system not responding or out of adjustment.

Cummins ISB4.5 CM2150 Fault Code: 3697 PID: SID 254 SPN: 630 FMI: 12 Engine Control Module Calibration Memory – Bad Intelligent Device or Component.

Cummins ISB4.5 CM2150 Fault Code: 3681 PID: 411 SPN: 3228 FMI: 0 Aftertreatment outlet NOx sensor power supply – Data erratic, intermittent, or incorrect.

Cummins ISB4.5 CM2150 Fault Code: 3679 PID: SPN: 3361 FMI: 11 Aftertreatment Diesel Exhaust Fluid Dosing Unit – Root Cause Not Known.

Cummins ISB4.5 CM2150 Fault Code: 3651 PID: SID 254 SPN: 3031 FMI: 18 Aftertreatment Diesel Exhaust Fluid Tank Temperature – Data Valid But Below Normal Operating Range – Moderately Severe Level.

WARNING!