Cummins ISB4.5 CM2150 Fault Code: 356 PID: SPN: 132 FMI: 3 Engine Intake Air Mass Flow Sensor Circuit – Voltage Above Normal or Shorted to High Source.

Posted by PerDiezel Solutions on January 20, 2026

Circuit Description
The mass air flow sensor is a frequency based device. A constant voltage is applied to a heated wire. This wire is positioned in the air stream and is heated by the electrical current that the voltage produces. As air flows across it, it cools down. The heated wire or film is a positive temperature coefficient (ptc) resistor. This means that the resistance drops when the temperature drops. The drop in resistance allows more current to flow through the wire in order to maintain the programmed temperature. This current is changed to a frequency which is sent to the engine control module (ECM) and interpreted as air flow. Adjustments for air temperature and humidity are taken into consideration since they also affect the temperature of the heated wire or film. The mass air flow sensor receives a 12 volt power supply from the ECM.

Component Location
The mass air flow sensor is located in the air box of the intake system.

Conditions for Running the Diagnostics
This diagnostic consists of two parts, an engine off and an engine running portion. The engine off portion runs only at initial key ON. The engine running portion runs when the EGR valve is commanded closed, and compares an estimated charge air flow value to the mass air flow sensor reading.

Conditions for Setting the Fault Codes
This diagnostic sets if the mass air flow sensor reports a value higher than what is allowable for the sensor at key ON, or when the engine is operating with the EGR valve closed.

Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE light and/or the malfunction indicator lamp (MIL) immediately when the diagnostic runs and fails.

Conditions for Clearing the Fault Code
-To validate the repair, start the engine and let it idle for 1 minute.
-The ECM will turn off the amber CHECK ENGINE light immediately after the diagnostic runs and passes.
-The ECM will turn off the MIL after three consecutive ignition cycles that the diagnostic runs and passes.
-This fault code and MIL can also be cleared with INSITE™ electronic service tool.

Shop Talk
The mass air flow sensor can not be cleaned or serviced, and must be replaced if contaminated or damaged.

Possible Causes
-Mass air flow sensor malfunction
-ECM malfunction
-Mass air flow sensor return circuit open
-Signal circuit shorted to voltage in harness or sensor
-Intermittent fault condition.

Cummins ISB4.5 CM2150 Fault Code: 352 PID: SID 212 SPN: 3509 FMI: 4 Sensor Supply 1 Circuit – Voltage Below Normal or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 351 PID: SID 251 SPN: 627 FMI: 12 Injector Power Supply – Bad Intelligent Device or Component.

Cummins ISB4.5 CM2150 Fault Code: 346 PID: 253 SPN: 630 FMI: 12 Engine Control Module Calibration Memory Software – Bad Intelligent Device or Component.

Cummins ISB4.5 CM2150 Fault Code: 343 PID: SID 254 SPN: 629 FMI: 12 Electronic Control Module Warning Internal Hardware Failure – Bad Intelligent Device or Component.

Cummins ISB4.5 CM2150 Fault Code: 339 PID: SID 87 SPN: 1267 FMI: 4 Idle Shutdown Vehicle Accessories Relay Driver Circuit – Voltage Below Normal, or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 338 PID: SID 87 SPN: 1267 FMI: 3 Idle Shutdown Vehicle Accessories Relay Driver Circuit – Voltage Above Normal, or Shorted to High Source.

WARNING!