Cummins ISB4.5 CM2150 Fault Code: 3418 PID: SPN: 191 FMI: 19 Transmission Output Shaft Speed – Received Network Data In Error.

Posted by PerDiezel Solutions on January 21, 2026

Circuit Description
Normally, switches, accelerators, and other components are connected to the engine control module (ECM) directly through individual wires. Multiplexing allows those same components to be hard wired to an original equipment manufacturer (OEM) vehicle electronic control unit (VECU) or transmission electronic control unit (ECU) in the cab. Then component values and states from components such as sensors, accelerators, and switches can be transmitted from the OEM VECU to the Cummins® ECM over the SAE J1939 data link.

Messages sent from OEM VECUs or transmission ECUs are received by the Cummins® ECM and used for controlling the engine. The Cummins® ECM and OEM VECU(s) must be configured properly, so that proper operation of the multiplexed components will occur.

Component Location
The SAE J1939 data link wiring and the SAE J1939 devices vary by OEM options.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the key switch is in the ON position or when the engine is running.

Conditions for Setting the Fault Codes
The OEM VECU determines that there is a malfunction of the transmission output shaft speed sensor.

Action Taken When the Fault Code is Active
-The ECM illuminates the amber CHECK ENGINE lamp and/or the malfunction indicator lamp (MIL) immediately when the diagnostic runs and fails.

Conditions for Clearing the Fault Code
-To validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.
-The fault code status displayed by INSITE™ electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
-The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
-The Reset All Faults command in INSITE™ electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for on board diagnostic (OBD) applications.

Shop Talk
The J1939 multiplexing controller has indicated a malfunction of the transmission output shaft speed sensor.

Cummins ISB4.5 CM2150 Fault Code: 3383 PID: 411 SPN: 3058 FMI: 0 Engine Exhaust Gas Recirculation System – Data Valid But Above Normal Operating Range – Moderately Severe Level.

Cummins ISB4.5 CM2150 Fault Code: 3382 PID: SPN: 3058 FMI: 18 Engine Exhaust Gas Recirculation System – Data Valid But Below Normal Operating Range – Moderately Severe Level.

Cummins ISB4.5 CM2150 Fault Code: 3228 PID: SPN: 191 FMI: 9 Transmission Output Shaft Speed – Abnormal Update Rate.

Cummins ISB4.5 CM2150 Fault Code: 3226 PID: SPN: 91 FMI: 9 SAE J1939 Multiplexed Accelerator Pedal or Lever Sensor System – Abnormal Update Rate.

Cummins ISB4.5 CM2150 Fault Code: 3261 PID: SID 254 SPN: 4342 FMI: 5 Aftertreatment Diesel Exhaust Fluid Line Heater 2 Circuit – Current Below Normal or Open Circuit.

Cummins ISB4.5 CM2150 Fault Code: 3258 PID: SID 254 SPN: 4340 FMI: 5 Aftertreatment Diesel Exhaust Fluid Line Heater 1 Circuit – Current Below Normal or Open Circuit.

WARNING!