Cummins ISB CM850 (2003-06) Fault Code: 731 (Marine) PID: SID 64 SPN: 723 FMI: 7 Engine Speed Sensor/Position Camshaft and Crankshaft Misalignment – Mechanical System Not Responding Properly or Out of Adjustment. Mechanical misalignment between the crankshaft and camshaft engine speed sensors.
This fault will become active anytime the ECM receives a signal from both the primary EPS (crankshaft sensor) and the backup EPS (camshaft sensor), and the ECM determines that the camshaft and crankshaft signals are not in the correct phase. If this fault code is active immediately following a repair that includes camshaft removal, it is likely that the camshaft gear was installed incorrectly and is not timed correctly.
1)Replace the camshaft position sensor. Refer to Procedure 019-363 in Section 19.
2)Replace the crankshaft position sensor.
3)Replace the tone wheel.
4)Replace, tighten, or clean the ground wires or connections.
5)Remove and install camshaft to properly align timing marks at TDC.
6)Replace the crankshaft assembly
Cummins ISB CM850 (2003-06) Fault Code: 731 (Auto) PID: SID 64 SPN: 732 FMI: 7 Engine Speed Sensor/Position Camshaft and Crankshaft Misalignment – Mechanical System Not Responding Properly or Out of Adjustment. Mechanical misalignment between the crankshaft and camshaft engine speed sensors.
Cummins ISB CM850 (2003-06) Fault Code: 692 PID: SPN: 1172 FMI: 4 Turbocharger Number 1 Compressor Inlet Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the turbocharger compressor inlet air temperature sensor circuit.
Cummins ISB CM850 (2003-06) Fault Code: 691 PID: SPN: 1172 FMI: 3 Turbocharger Number 1 Compressor Inlet Temperature Sensor Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage detected at the turbocharger compressor inlet air temperature circuit.
Cummins ISB CM850 (2003-06) Fault Code: 689 PID: 190 SPN: 190 FMI: 2 Engine Crankshaft Speed/Position – Data Erratic, Intermittent, or Incorrect. Loss of signal from crankshaft sensor.
Cummins ISB CM850 (2003-06) Fault Code: 688 PID: 98 SPN: 98 FMI: 0 Engine Oil Level ? Data Valid But Above Normal Operational Range ? Most Severe Level. High oil level has been detected by the oil level sensor.
Cummins ISB CM850 (2003-06) Fault Code: 687 (ISC) PID: 103 SPN: 103 FMI: 1 Turbocharger Number 1 Speed Low – Data Valid but Below Normal Operational Range – Moderately Severe Level. Low turbocharger speed detected by the ECM.
