Cummins ISB CM850 (2003-06) Fault Code: 649 PID: SID 153 SPN: 1378 FMI: 11 Change Lubricating Oil and Filter – Condition Exists. Change engine oil and filter.
This fault code will only become active if the maintenance monitor is enabled in INSITE?. Make sure that the oil and filter are changed before clearing the fault.
Possible repiars:
1)Change the engine lubricating oil and filter.
Cummins ISB CM850 (2003-06) Fault Code: 599 PID: SID 25 SPN: 640 FMI: 14 Auxiliary Commanded Dual Output Shutdown – Special Instructions. The engine protection limit has been exceeded for the dual outputs calibrated limits.
Cummins ISB CM850 (2003-06) Fault Code: 598 PID: 167 SPN: 167 FMI: 11 Electrical Charging System Voltage Low – Data Valid But Below Normal Operating Range – Most Severe Level. Very low battery voltage detected by the battery voltage monitor feature.
Cummins ISB CM850 (2003-06) Fault Code: 597 PID: 167 SPN: 167 FMI: 1 Electrical Charging System Voltage Low – Data Valid But Below Normal Operating Range – Moderately Severe Level. Low battery voltage detected by the battery voltage monitor feature.
Cummins ISB CM850 (2003-06) Fault Code: 596 PID: 167 SPN: 167 FMI: 0 Electrical Charging System Voltage High – Data Valid But Above Normal Operating Range – Moderately Severe Level. High battery voltage detected by the battery voltage monitor feature.
Cummins ISB CM850 (2003-06) Fault Code: 595 (ISB) PID: 103 SPN: 103 FMI: 0 Turbocharger Number 1 speed high – warning level. High turbocharger speed has been detected.
Cummins ISB CM850 (2003-06) Fault Code: 595 (ISC) PID: 103 SPN: 103 FMI: 0 Turbocharger Number 1 Speed High – Data Valid but Above Normal Operational Range – Moderately Severe Level. High turbocharger speed has been detected.
