Cummins ISB CM850 (2003-06) Fault Code: 415 (Sensor) PID: 100 SPN: 100 FMI: 11 Engine Oil Rifle Pressure – Data Valid but Below Normal Operational Range – Most Severe Level. Oil pressure signal indicates oil pressure is below the engine protection critical limit.
Possible causes:
1)Low oil pressure
2)Incorrect oil level.
Possible repairs:
1)Replace the pressure sensor.
Cummins ISB CM850 (2003-06) Fault Code: 412 PID: SID 250 SPN: 608 FMI: 2 SAE J1587/J1922 data link – can not transmit. Communication between the ECM and another device on the J1587/J1922 data link has been lost.
Cummins ISB CM850 (2003-06) Fault Code: 387 PID: SID 221 SPN: 1043 FMI: 3 Accelerator Pedal or Lever Position Sensor Supply Voltage Circuit – Voltage Above Normal or Shorted to High Source. High voltage detected at sensor supply circuit for the accelerator pedal or lever position sensor.
Cummins ISB CM850 (2003-06) Fault Code: 386 PID: SID 212 SPN: 1079 FMI: 3 Sensor Supply Voltage number 1 Circuit – Voltage Above Normal or Shorted to High Source. High voltage detected at sensor supply number 1 circuit.
Cummins ISB CM850 (2003-06) Fault Code: 352 PID: SID 212 SPN: 1079 FMI: 4 Sensor Supply Voltage Number 1 Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected at sensor supply number 1 circuit.
Cummins ISB CM850 (2003-06) Fault Code: 351 PID: SID 254 SPN: 627 FMI: 12 Injector Power Supply – Bad Intelligent Device or Component. The ECM measured injector boost voltage is low.
Cummins ISB CM850 (2003-06) Fault Code: 343 PID: SID 254 SPN: 629 FMI: 12 Engine Control Module Warning Internal Hardware Failure – Bad Intelligent Device or Component.
