Cummins ISB CM850 (2003-06) Fault Code: 2217 PID: SID 240 SPN: 630 FMI: 111 Engine Control Module Calibration Program Memory (RAM) Corruption – Condition Exists. Severe loss of data from the ECM.

Posted by PerDiezel Solutions on January 18, 2026

On-Board Diagnostics (OBD) Information (Euro 4 Certified Engines):

1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
2)The ECM turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail. The MIL lamp and fault code can also be cleared using the INSITE? service tool.
3)The fault code will be cleared from memory after 40 consecutive drive cycles where the diagnostic runs and passes.

On-Board Diagnostics (OBD) Information (Euro 4 Stage 1+ Certified Engines):

1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
2)An engine torque derate will be activated after 50 hours of engine operation with the fault code active.
3)The ECM turns OFF the malfunction indicator lamp (MIL) after 1 ignition cycle that the diagnostic runs and does not fail. The MIL lamp cannot be cleared using the INSITE? service tool.
4)The fault code will be cleared from memory after 400 days or 9600 hours of engine operation.

Possible repairs:

1)Charge or replace the battery.
2)Tighten the loose connections and clean the terminals.
3)Replace the fuses.
4)Repair or replace the OEM harness.

Cummins ISB CM850 (2003-06) Fault Code: 2216 (ISC) PID: 94 SPN: 94 FMI: 1 Fuel Pump Delivery Pressure High – Data Valid but Above Normal Operational Range – Moderately Severe Level. The ECM has detected that fuel pressure is higher than commanded pressure.

Cummins ISB CM850 (2003-06) Fault Code: 2216 (ISB) PID: 94 SPN: 94 FMI: 0 Fuel pump delivery pressure – data valid but above normal operational range – moderately severe level. The ECM has detected fuel pressure in the fuel rail that is higher than the commanded pressure.

Cummins ISB CM850 (2003-06) Fault Code: 2215 (ISC) PID: 94 SPN: 94 FMI: 0 Fuel Pump Delivery Pressure Low – Data Valid but Below Normal Operational Range – Moderately Severe Level. The ECM has detected that fuel pressure is lower than commanded pressure.

Cummins ISB CM850 (2003-06) Fault Code: 2215 (ISB) PID: 94 SPN: 94 FMI: 1 Fuel Pump Delivery Pressure – Data Valid but Below Normal Operational Range – Moderately Severe Level. The ECM has detected the fuel pressure in the fuel rail is lower than the commanded performance.

Cummins ISB CM850 (2003-06) Fault Code: 2195 PID: SID 51 SPN: 703 FMI: 14 Auxiliary Equipment Sensor Input Engine Protection Critical – Special Instructions. OEM switch signal on the OEM harness indicates engine protection condition.

Cummins ISB CM850 (2003-06) Fault Code: 2186 PID: SID 232 SPN: FMI: 4 Sensor Supply Voltage 4 Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected at +5 VDC sensor supply circuit to the accelerator pedal position sensor.

WARNING!