Cummins ISB CM850 (2003-06) Fault Code: 1992 PID: SPN: 190 FMI: 0 Engine Crankshaft Speed/Position – Data Valid but Above Normal Operational Range – Moderately Severe Level.

Posted by PerDiezel Solutions on January 18, 2026

Cummins ISB CM850 (2003-06) Fault Code: 1992 PID: SPN: 190 FMI: 0 Engine Crankshaft Speed/Position – Data Valid but Above Normal Operational Range – Moderately Severe Level. Engine crankshaft speed/position SIGNAL indicates engine speed above engine protection limit.

This fault code is only applicable to engines powering generator sets.

Possible causes:

1)External fuel sources drawn into the intake air passage
2)Reverse powering (motoring) of the engine
3)Tampering of the engine crankshaft speed/position and engine camshaft speed/position sensors.

Inspect the intake manifold for sources of flammable vapors. Check the turbocharger seals to verify that there are no oil leaks. Inspect the engine crankshaft speed/position and engine camshaft speed/position sensors for damage or tampering.

Possible repairs:

1)Replace the damaged section of harness or damaged engine crankshaft speed/position sensor.
2)Replace the ECM.

Cummins ISB CM850 (2003-06) Fault Code: 1911 PID: 157 SPN: 157 FMI: 0 Injector Metering Rail Number 1 Pressure – Data Valid But Above Normal Operating Range – Most Severe Level. Fuel pressure signal indicates that fuel pressure has exceeded the maximum limit for the given engine rating.

Cummins ISB CM850 (2003-06) Fault Code: 1892 PID: 84 SPN: 84 FMI: 1 Wheel-Based Vehicle Speed ? Data Valid but Below Normal Operational Range ? Moderately Severe Level. The ECM lost the vehicle speed signal.

Cummins ISB CM850 (2003-06) Fault Code: 1851 PID: SPN: 3249 FMI: 10 Exhaust Gas Temperature 2 ? Abnormal Rate of Change. The catalyst outlet temperature sensor is not responding to a change in engine operating conditions.

Cummins ISB CM850 (2003-06) Fault Code: 1849 PID: SPN: 3241 FMI: 10 Exhaust Gas Temperature 1 ? Abnormal Rate of Change. The catalyst inlet temperature sensor is not responding to a change in engine operating conditions.

Cummins ISB CM850 (2003-06) Fault Code: 1848 PID: 105 SPN: 105 FMI: 10 Intake Manifold 1 Temperature ? Abnormal Rate of Change. The intake manifold temperature sensor is not responding to a change in engine operating conditions.

Cummins ISB CM850 (2003-06) Fault Code: 1846 PID: SPN: 97 FMI: 4 Water-in-Fuel Indicator Sensor Circuit – Voltage Below Normal or Shorted to Low Source (For Generator Engines Only). Low voltage detected at the water-in-fuel indicator circuit.

WARNING!