Cummins ISB CM850 (2003-06) Fault Code: 1717 PID: SPN: 3241 FMI: 15 Exhaust Gas Temperature 1 ? Data Valid but Above Normal Operational Range ? Least Severe Level. High catalyst inlet temperature has been detected.
This fault is triggered when the temperature at the catalyst inlet exceeds the maximum allowable temperature for a given engine rating. Leaks in the charge air system or a faulty turbocharger can cause high exhaust gas temperature.
1)The ECM illuminates the appropriate amber or red fault lamp when the diagnostic runs and fails.
2)The ECM turns OFF the appropriate fault lamp when the diagnostic runs and passes.
1)Replace the turbocharger.
2)Replace the exhaust gas temperature #1 sensor.
Cummins ISB CM850 (2003-06) Fault Code: 1716 PID: SPN: 411 FMI: 11 Auxiliary Temperature Sensor Input 1 Circuit – Root Cause Not Known. High temperature detected by the OEM temperature sensor or by the engine coolant temperature sensor.
Cummins ISB CM850 (2003-06) Fault Code: 1713 PID: SPN: 3363 FMI: 0 Catalyst Tank Heater Circuit – Data Valid But Above Normal Operating Range – Moderately Severe Level. The catalyst tank heater is continuously in the on position.
Cummins ISB CM850 (2003-06) Fault Code: 1712 PID: SPN: 3363 FMI: 1 Catalyst Tank Heater Circuit ? Data Valid But Below Normal Operating Range ? Moderately Severe Level. The catalyst solution temperature did not increase when the catalyst tank heater was commanded on.
Cummins ISB CM850 (2003-06) Fault Code: 1711 PID: SPN: 3361 FMI: 9 Dosing Control Unit Data Link ? Abnormal Update Rate. Data Link communications between the ECM and the Dosing Control Unit have been interrupted.
Cummins ISB CM850 (2003-06) Fault Code: 1699 PID: SPN: 1761 FMI: 2 Catalyst Tank Level Sensor – Data Erratic, Intermittent, or Incorrect. Catalyst solution level is not changing with engine operating conditions.
Cummins ISB CM850 (2003-06) Fault Code: 1698 PID: SPN: 3489 FMI: 4 Aftertreatment #1 Air Enable Actuator ? Voltage Below Normal, or Shorted to Low Source. Low signal voltage has been detected at the catalyst air solenoid circuit.
