The theft deterrent feature has been enabled. The correct password must be entered in order to disable the theft deterrent. Then, the engine can be started. CAT 3126B Fault Code: 96-04 PID: Flash Code 00 SPN: 96 FMI: 4 Fuel Level Voltage Low CAT 3126B Fault Code: 96-03 PID: Flash Code 00 SPN: 96 FMI: 3 Fuel Level Voltage High CAT 3126B Fault Code: 247-11 PID: Flash Code 00 SPN: FMI: Service Brake Switch #2 Fault CAT 3126B Fault Code: 246-11 PID: Flash Code 00 SPN: FMI: Service Brake Switch #1 Fault CAT 3126E Fault Code: 5-11 PID: Flash Code...

The Engine Control Module (ECM) detects the following conditions: •The engine is cranking.•The theft deterrent is active. The diagnostic code is active only. The diagnostic code will be active when the theft deterrent is enabled and the engine is cranking for more than five seconds. The engine will not start until the correct password is entered. CAT 3126B Fault Code: 224-11 PID: Flash Code 00 SPN: FMI: Theft Deterent Active CAT 3126B Fault Code: 96-04 PID: Flash Code 00 SPN: 96 FMI: 4 Fuel Level Voltage Low CAT 3126B Fault Code: 96-03 PID: Flash Code 00 SPN: 96 FMI: 3...

This condition indicates that the J1939 data link is receiving information from a specified device but the information is incomplete or corrupted. The parameter “Powertrain Data Link” must be programmed to J1939. One of the following conditions must be met: •The device is broadcasting a fault code.•The Engine Control Module (ECM) is unsuccessful in receiving a specific message from a device.•The device is broadcasting a code that is not supported. The power train data link is designed to offer electronically controlled Anti-Lock Brakes (ABS), traction control systems, and/or transmission controls. This is accomplished by a momentary reduction of engine rpm...

This condition indicates that the SAE J1939 data link is not communicating correctly. The parameter “Powertrain Data Link” must be programmed to J1939. The power train data link is designed to offer electronically controlled Anti-Lock Brakes (ABS), traction control systems, and/or transmission controls. This is accomplished by a momentary reduction of engine rpm and/or engine torque, that is triggered by a signal from an off-engine control module for the ABS, the traction control, or the transmission. An off-engine control module is a control module that is not part of theCaterpillar engine control system. Possible Causes: 1) ECM Connection/Harness2) Other devices...

The Engine Control Module (ECM) detects the following conditions: •The ECM is unsuccessful in receiving a message from a J1939 source.•The ECM is not receiving a valid message from a J1939 source The power train data link is designed to offer electronically controlled Anti-Lock Brakes (ABS), traction control systems, and/or transmission controls. This is accomplished by a momentary reduction of engine rpm and/or engine torque, that is triggered by a signal from an off-engine control module for the ABS, the traction control, or the transmission. An off-engine control module is a control module that is not part of theCaterpillar engine...