The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector solenoid. CAT 3126E Fault Code: 105-03 PID: Flash Code 38 SPN: FMI: Intake Manifold Air Temperature Sensor Open Circuit CAT 3126E Fault Code: 84-10 PID: Flash Code 36 SPN: FMI: Vehicle Speed Rate of Change CAT 3126E Fault Code: 84-08 PID: Flash Code 36 SPN: FMI: Vehicle Speed Out of Range CAT 3126E Fault Code: 84-02 PID: Flash Code 36 SPN: FMI: Invalid Vehicle Speed Signal CAT 3126E Fault Code:...

The ECM detects the following conditions: •The intake manifold air temperature is greater than 109 °C (228 °F) for more than two seconds.•The engine has been running for at least 30 seconds.•The engine coolant temperature is above 99 °C (210 °F). Probable Causes: 1) Engine coolant low2) Debris/low air flow in the charge air cooler3) Heavy load + high ambient air temperature CAT 3126E Fault Code: 105-00 PID: Flash Code 64 SPN: 1636 FMI: 15 High Intake Manifold Air Temperature Warning CAT 3126E Fault Code: 111-11 PID: Flash Code 62 SPN: 111 FMI: 18 Low Coolant Level Warning CAT 3126E...

The Engine Control Module (ECM) detects the following conditions: •The signal voltage from the atmospheric pressure sensor is greater than 4.9 VDC for more than 30 seconds.•The ECM has been powered for at least two seconds. The Engine Control Module (ECM) continuously creates a pull-up voltage on the signal wire for each sensor. The ECM uses this pull-up voltage in order to detect a problem in the signal circuit. When the ECM detects voltage that is above a threshold on the signal wire, the ECM activates a -3 diagnostic code. When the ECM detects voltage that is below a threshold...

The Engine Control Module (ECM) detects the following conditions: •The signal voltage from the atmospheric pressure sensor is less than 0.2 VDC for more than 30 seconds.•The ECM has been powered for at least two seconds.•The engine is not running or the engine has been running for more than ten seconds. The Engine Control Module (ECM) continuously creates a pull-up voltage on the signal wire for each sensor. The ECM uses this pull-up voltage in order to detect a problem in the signal circuit. When the ECM detects voltage that is above a threshold on the signal wire, the ECM...

The Boost Pressure signal voltage is below acceptable range. CAT 3126E Fault Code: 252-11 PID: Flash Code 59 SPN: 631 FMI: 11 Incorrect Engine Software CAT 3126E Fault Code: 231-11 PID: Flash Code 58 SPN: 639 FMI: 12 J1939 Data Link Fault CAT 3126E Fault Code: 231-02 PID: Flash Code 58 SPN: 639 FMI: 2 J1939 Data Incorrect CAT 3126E Fault Code: 253-14 PID: Flash Code 56 SPN: FMI: Truck Manufacturer Paremater Not Programmed CAT 3126E Fault Code: 253-02 PID: Flash Code 56 SPN: 630 FMI: 2 Check Customer or System Parameters CAT 3126E Fault Code: 168-02 PID: Flash Code...