The Engine Control Module (ECM) detects the following conditions: •The ECM detects a high current condition (short circuit) for one second while the ECM is attempting to energize the solenoids for cylinders 1, 2, 5, and 6.•The engine retarder switch is in the medium or high position. Probable Causes: 1) ECM Connection/Harness2) Harness between the ECM and valve cover base3) Engine retarder solenoid failure4) Harness under valve cover5) ECM Failure6) Harness at bulkhead connector CAT 3406E (Prefix 1MM or 2WS) Fault Code: 14 PID: SPN: 122 FMI: 5 Med/High Retarder current low CAT 3406E (Prefix 1MM or 2WS) Fault Code:...

This code indicates that the engine has been derated in order to prevent excessive exhaust temperatures. The engine will only be derated to a level that will allow the exhaust temperature to be lowered to an acceptable level. This code will be logged once the engine has been derated by more than 4%. This is not a code, but an event being logged . Talk to the driver to see if the engine was running under heavy loads or climbing steep hills. CAT 3406E (Prefix 1MM or 2WS) Fault Code: 14 PID: SPN: 122 FMI: 6 Med/High Retarder current high...

This code indicates that the engine has been derated in order to prevent excessive exhaust temperatures. The engine will only be derated to a level that will allow the exhaust temperature to be lowered to an acceptable level. This code will be logged once the engine has been derated by more than 4%. This is not a code, but an event being logged . Talk to the driver to see if the engine was running under heavy loads or climbing steep hills. CAT 3406E (Prefix 1MM or 2WS) Fault Code: 16 PID: SPN: 173 FMI: 0 High Exhaust Gas Temperature...

The Engine Control Module (ECM) detects the following conditions: •The 5 volt supply is greater than 5.16 VDC for more than one second.•The ECM has been powered for at least three seconds. Sensors that are regulated with 5V: Boot pressure, atmosphere pressure, engine oil pressure, coolant temperature, intake manifold air temperature, fuel temperature Probable Causes: 1) ECM Connection/Harness2) Sensor Failure3) Sensor wiring failure4) ECM Failure CAT 3406E (Prefix 1MM or 2WS) Fault Code: 21 PID: SPN: 41 FMI: 4 8 Volt Supply voltage low CAT 3406E (Prefix 1MM or 2WS) Fault Code: 21 PID: SPN: 41 FMI: 3 8 Volt...

The Engine Control Module (ECM) detects the following conditions: •The 5 volt supply is less than 4.84 VDC for more than one second.•The ECM has been powered for at least three seconds. Sensors that are regulated with 5V: Boot pressure, atmosphere pressure, engine oil pressure, coolant temperature, intake manifold air temperature, fuel temperature Probable Causes: 1) ECM Connection/Harness2) Sensor Failure3) Sensor wiring failure4) ECM Failure CAT 3406E (Prefix 1MM or 2WS) Fault Code: 21 PID: SPN: 232 FMI: 3 5 Volt Supply voltage high CAT 3406E (Prefix 1MM or 2WS) Fault Code: 21 PID: SPN: 41 FMI: 4 8 Volt...