The Engine Control Module (ECM) detects the following conditions:
•The signal voltage from the intake manifold air temperature sensor is less than 0.2 VDC for more than eight seconds.
•The ECM has been powered for at least two seconds.
Probable Causes:
1) ECM Connection/Harness
2) If code 232-3 or 232-4 (5 Volt Supply voltage codes) are active, troubleshoot those instead
3) Temperature sensor failure
4) Temperature sensor harness
5) ECM Failure
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 38 PID: SPN: 105 FMI: 3 Intake Manifold Air Temperature voltage high
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 36 PID: SPN: 84 FMI: 10 Vehicle Speed signal rate of change
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 36 PID: SPN: 84 FMI: 8 Vehicle Speed signal out of range
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 36 PID: SPN: 84 FMI: 2 Vehicle Speed signal invalid
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 35 PID: SPN: 190 FMI: 0 Engine Overspeed Warning
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 34 PID: SPN: 190 FMI: 12 Primary Engine Speed loss of signal
