The ECM detects the following conditions:
•The vehicle speed signal indicates a constant MPH.
•The “VSL Protection” parameter is programmed to a value that is less than 2120 rpm.
Probable Causes:
1) Fuel system restriction (Uncommon, but possible)
2) If speedometer is not accurate, then ECM is not programmed correctly
3) Vehicle speed sensor
4) Vehicle speed sensor wiring
5) ECM Connection/Harness
6) Speedometer failure
7) ECM Failure
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 35 PID: SPN: 190 FMI: 0 Engine Overspeed Warning
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 34 PID: SPN: 190 FMI: 12 Primary Engine Speed loss of signal
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 34 PID: SPN: 64 FMI: 12 Secondary Engine Speed loss of signal
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 33 PID: SPN: 32 FMI: 11 Turbo Wastegate Solenoid current mismatch
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 33 PID: SPN: 32 FMI: 6 Turbo Wastegate Solenoid current high
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 33 PID: SPN: 32 FMI: 5 Turbo Wastegate Solenoid current low
